Dispatch online(469) 555-0118
Irving, TXLas ColinasCoppellGrapevine

Power,done rightthe first time.

Panel upgrades, EV chargers, lighting and the flickering outlet you've been ignoring. Licensed master electricians, permitted work, and a flat price before we touch a wire.

LicenseTX Master Electrician
PricingFlat-rate, written
Warranty2 years, labor
Flip a breaker
Main panel · 200A1 / 6 on
01
Panel check · 30 seconds

Is your panel the problem?

Tick anything that sounds like your house. It's the same checklist our electricians run through on a first visit.

Reading

02
EV charger estimator

Charge at home by next week

A Level 2 charger adds roughly 20 to 30 miles of range per hour. Most of the price comes down to two things: how far the garage is from your panel, and whether the panel has room.

Panel sizeCheck the main breaker
25 ft
5 ft · same wall120 ft
I already own the charger
Tesla Wall Connector, ChargePoint, etc.
Estimated installed price
$950
Lock in this price on a site visit →

Estimate for a typical attached garage. Final price is confirmed in writing after a 20-minute site check.

03
Spec sheet

What we wire

Residential only. Every job that needs a permit gets one, and we schedule the city inspection for you.

CodeServiceScopeFrom
PNL

Panel upgrades

100A to 200A service, Federal Pacific and Zinsco replacements, meter base and grounding.

$2,400
EVC

EV chargers

Level 2 circuits for any brand, load calculation included, permitted and inspected.

$650
LGT

Lighting

Recessed cans, under-cabinet LEDs, landscape lighting and fixture swaps.

$189
GEN

Generators

Standby generator hookups and manual transfer switches for portable units.

$1,100
TRB

Troubleshooting

Dead outlets, tripping breakers, flickering lights. Diagnosis credited to the repair.

$99
SMT

Smart home

Smart switches, video doorbells, whole-home surge protection and dedicated circuits.

$149
04
How a job runs

Permitted. Inspected. Signed off.

Plenty of electrical work in North Texas gets done without a permit. That's a problem the day you sell the house or file an insurance claim.

Step 01 · Day 1

Site check

We look at the panel, the run and the load, then quote a flat price on the spot.

Step 02 · Day 1–3

Permit

We pull the permit with your city. You don't fill out a single form.

Step 03 · Install day

Wire it

Usually one day. Power is off for as little time as possible, and we tell you when.

Step 04 · Inspection

Sign-off

We meet the city inspector and send you the approved permit for your records.

FAQ

Straight answers

Q.01Do I need a panel upgrade for an EV charger?

Not always. Many 200A panels have room for a 40 or 48 amp circuit. Older 100A panels often don't. We run a load calculation on the first visit, so you only upgrade if the numbers say you have to.

Q.02My breaker keeps tripping. Is that dangerous?

The breaker is doing its job, but it's telling you something. Too much on one circuit, a short or a failing breaker are the usual causes. If it trips again right after you reset it, leave it off and call us.

Q.03What about a warm outlet or burning smell?

Treat it as urgent. Shut off that circuit at the panel, don't plug anything back in, and call. If you see smoke or flame, get out and call 911 first.

Q.04Do you pull permits?

Yes, for every job that requires one. The permit fee is listed separately on your quote, so you see exactly what the city charges.

Q.05How soon can you come out?

Troubleshooting calls are usually same day or next day. Panel upgrades and EV chargers are typically installed within a week of your site check, depending on permit turnaround.

Flip the switch.

Licensed electricians for Irving, Las Colinas, Coppell, Grapevine, Euless and Farmers Branch. Call or text, and a person picks up.

(469) 555-0118
Call nowEV estimate